More About Connecting Client Computers - Toshiba Magnia SG20 User Manual

Setting Up Your Local Area Network
❖
Where the temperature and humidity change constantly, near an air-conditioning
vent, fan, or heat source
❖
Near liquids or corrosive chemicals
CAUTION: If debris or liquid gets in the Magnia SG20, shut it down, set the Power/
Shutdown button to Off, and unplug the power cable from the AC outlet.
Do not turn the unit back on. Contact an authorized Toshiba service provider
immediately.
Cleaning the Magnia SG20
If the Magnia SG20's exterior case is dirty or stained, clean it with a soft cloth. If
necessary, moisten the cloth with water. Never use harsh chemicals to clean the case.
Power requirements
Before plugging the power cable into a wall outlet, make sure the AC power source and
the over-current protector (circuit breaker current rating) are sufficient to handle the
requirements of the Magnia SG20.
To ensure a continuous supply of power, Toshiba recommends the use of an
Uninterruptable Power Supply (UPS).
WARNING: To ensure proper grounding of the Magnia SG20 and avoid a possible
fire hazard, only use the power cable provided.
Set the power supply setting on the back of the Magnia SG20 to match your local voltage
requirement.
Power supply setting

More about connecting client computers

The Quick start procedure
client computers for the local network if you have already set it up.
You can connect clients to the Magnia SG20 and configure them quickly and easily using
the Magnia SG20 Client Setup CD. This is the recommended method of setting up client
computers for your private network.
Power supply setting
on page 22 explains the basics of connecting and configuring
More about connecting client computers
67