Subaru 2001 FORESTER Service Manual page 34

8) Disconnect parking brake cable from parking
lever.
B: INSTALLATION
1) Clean back plate and wheel cylinder.
2) Apply grease to portions indicated by arrows in
Figure.
Brake grease:
Dow Corning Molykote No. 7439 (Part No.
725191460)
3) Apply grease to adjusting screw and both ends
of adjuster.
Brake grease:
Dow Corning Molykote No. 7439 (Part No.
725191460)
4) Connect upper shoe return spring to shoes.
5) Connect parking brake cable to parking lever.
REAR DRUM BRAKE SHOE
S405174A11
G4M0407
S4M0457B
BR-33
6) While positioning shoes (one at a time) in
groove on wheel cylinder, secure shoes.
(1) Wheel cylinder
(2) Shoe (Trailing)
7) Fix shoes by connecting hold-down cup to hold-
down pin.
8) Connect lower shoe return spring.
9) Set the outside diameter of brake shoes less
than 0.5 to 0.8 mm (0.020 to 0.031 in) in compari-
son with the inside diameter of brake drum.
10) Install drum.
C: INSPECTION
1) Measure the lining thickness.
Lining thickness:
Standard 4.1 mm (0.161 in)
Service limit 1.5 mm (0.059 in)
2) If the deformation or wear of back plate, shoe,
etc. are notable, replace them.
3) When the shoe return spring tension is exces-
sively weakened, replace it, taking care to identify
upper and lower springs.
Brake
S4M0458A
S405174A10