Brake
8. Rear Drum Brake Shoe
A: REMOVAL
S405174A18
1) Loosen wheel nuts, jack-up vehicle, support it
with safety stands, and remove wheel.
2) Release parking brake.
3) Remove brake drum from brake assembly.
NOTE:
¼ If it is difficult to remove brake drum, remove
adjusting hole cover from drum, and then turn
adjuster assembly pawls using a slot-type screw-
driver until brake shoe separates from the drum.
(1)
Back plate
(2)
Wheel cylinder
(3)
Adjuster ASSY pawls
(4)
Adjusting lever
(5)
Tightening direction
(6)
Push.
¼ If brake drum is difficult to remove, drive it out by
installing an 8-mm bolt into bolt hole in brake drum.
REAR DRUM BRAKE SHOE
4) Hold hold-down pin by securing rear of back
S405174
plate with your hand.
5) Disconnect hold-down cup from hold-down pin
by rotating hold-down cup.
6) Disconnect lower shoe return spring from
shoes.
S4M0369A
7) Remove shoes one by one from back plate with
adjuster.
CAUTION:
Be careful not to bend parking brake cable
excessively when removing brake shoes.
B4M0243
BR-32
(1)
Hold-down cup
(2)
Hold-down pin
(1)
Wheel cylinder
(2)
Adjuster
(3)
Back plate
(4)
Lower shoe return spring
(5)
Parking lever
(6)
Trailing shoe
S4M0451A
S4M0452
S4M0453A