Subaru 2001 FORESTER Service Manual page 57

Brake
2. AT MODEL
S405541A1802
¼ LHD model
1) Pull up parking brake lever.
2) Disconnect battery ground terminal from bat-
tery.
3) Remove instrument panel lower cover from
instrument panel.
4) Remove clevis pin which secures brake pedal
to brake booster operating rod. Also disconnect
stop light switch connector.
5) Remove two bolts and four nuts which secure
brake pedal to pedal.
¼ RHD model
NOTE:
For removal procedures, refer to "MT MODEL".
<Ref. to BR-54 MT MODEL, REMOVAL, Brake
Pedal.>
BRAKE PEDAL
B: INSTALLATION
1) Install in the reverse order of removal.
CAUTION:
¼ Be careful not to bend clutch cable too
much.
¼ Never fail to cover outer cable end with boot.
¼ Be careful not to kink accelerator cable.
¼ Make sure that holder and casing cap are
securely connected. (LHD model only)
(1)
(2)
G4M0324
(3)
(4)
(5)
2) Adjustment of clutch pedal <Ref. to BR-58
ASSEMBLY, Brake Pedal.>
3) Inspect after pedal installation <Ref. to BR-59
INSPECTION, Brake Pedal.>
BR-56
S405541A11
Casing cap
Accelerator cable
Toe board
Accelerator pedal bracket
Holder
B4M0159B