Subaru 2001 FORESTER Service Manual page 37

Brake
4) Install brake assembly on housing, and tighten
bolts to install back plate.
Tightening torque:
52 N·m (5.3 kgf-m, 38.3 ft-lb)
5) Install hub. <Ref. to DS-23, Rear Axle.>
6) Connect brake pipe, and tighten brake pipe
flange nut.
Tightening torque:
15 N·m (1.5 kgf-m, 10.8 ft-lb)
7) Connect ABS sensor to back plate. (only
vehicle equipped with ABS)
Tightening torque:
32 N·m (3.3 kgf-m, 24 ft-lb)
8) Apply grease to adjusting screw and both ends
of adjuster.
Brake grease:
Dow Corning Molykote No. 7439 (Part No.
725191460)
9) Install brake shoe.
INSTALLATION, Rear Drum Brake Shoe.>
10) Install drum. <Ref. to BR-34, INSTALLATION,
Rear Drum Brake Drum.>
11) Bleed air from brake system. <Ref. to BR-47,
Air Bleeding.>
REAR DRUM BRAKE ASSEMBLY
G4M0400
S4M0457B
<Ref. to BR-33,
BR-36
C: DISASSEMBLY
1) Remove right and left dust boots from wheel
cylinder.
(1) Bleeder cap
(2) Bleeder screw
(3) Spring
(4) Cylinder
(5) Cup
(6) Piston
(7) Boot
2) Remove piston, cup, spring and air bleeder
screw and cap.
D: ASSEMBLY
S405179A02
1) Clean all parts in brake fluid. Check and replace
faulty parts.
¼ Cup and boot for damage or fatigue
¼ Cylinder, piston and spring or damage or rust
formation
2) Assembly is the reverse order of disassembly.
(1) When installing the cup, use ST, apply
brake fluid to the frictional surface for smooth
installation and pay attention to cup direction.
(2) STs are available in different sizes.
CAUTION:
¼ When replacing the repair kit, make sure that
the sizes of cylinder and cup are the same as
those which were replaced.
¼ Use only the tool of the correct size.
ST: ADAPTER
Applicable size
19.0 mm (3/4 in)
S405179A06
B4M1126B
Part No.
926460000