Rear Drum Brake Assembly - Subaru 2001 FORESTER Service Manual

10. Rear Drum Brake Assembly

S405179
A: REMOVAL
S405179A18
1) Disconnect battery ground terminal from bat-
tery.
2) Loosen wheel nuts, jack-up vehicle, support it
with safety stands, and remove wheel.
3) Release parking brake.
4) Remove brake drum from brake assembly.
<Ref. to BR-34, REMOVAL, Rear Drum Brake
Drum.>
5) Remove brake shoe.
REMOVAL, Rear Drum Brake Shoe.>
6) Unscrew the brake pipe flare nut and discon-
nect brake pipe.
7) Disconnect ABS sensor from back plate. (only
vehicle equipped with ABS)
8) Remove hub. <Ref. to DS-23, Rear Axle.>
9) Remove the bolts installing back plate, and
then, remove brake assembly.
REAR DRUM BRAKE ASSEMBLY
<Ref. to BR-32,
G4M0399
G4M0400
BR-35
10) Remove the bolts installing wheel cylinder on
back plate, and remove it.
(1) Air bleeder
B: INSTALLATION
1) Clean back plate and wheel cylinder.
2) Install wheel cylinder on back plate, and tighten
bolts.
Tightening torque:
10 N·m (1.0 kgf-m, 7.2 ft-lb)
3) Apply grease to portions indicated by arrows in
Figure.
Brake grease:
Dow Corning Molykote No. 7439 (Part No.
725191460)
Brake
S4M0454A
S405179A11
S4M0454
G4M0407