Subaru 2001 FORESTER Service Manual page 53

Brake
4) Remove cable clamp, and disconnect PHV
cable from PHV.
CAUTION:
Carefully protect boot and inner cable from
damage when disconnecting PHV cable.
(1) PHV cable
(2) Clamp
5) Remove cable clamp from clutch pedal bracket.
LHD model
(1) Clamp
(2) PHV cable
(3) Clutch pedal
RHD model
(1) Clamp
(2) PHV cable
(3) Clutch pedal
6) Remove PHV cable.
HILL HOLDER
B: INSTALLATION
1. PHV (PRESSURE HOLD VALVE)
1) Install PHV onto side frame.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
2) Connect brake pipes to PHV.
Tightening torque:
15 N·m (1.5 kgf-m, 10.8 ft-lb)
CAUTION:
Confirm that brake pipes are not deformed
and/or damaged. Replace them with new ones
if necessary.
3) Install PHV cable to PHV.
S4M0242C
CAUTION:
If cable clamp (and clips) is damaged, replace
it with a new one.
4) Connect PHV cable with clips.
NOTE:
Avoid sharp bending of PHV cable as it may cause
breakage.
5) Apply grease to the following points.
¼ Hook portion of return spring
¼ Cable end portion of lever
Grease:
SUNLIGHT 2 (Part No. 003602010)
6) Be sure to bleed air from the brake system.
7) Adjust
S4M0244B
ADJUSTMENT, Hill Holder.>
CAUTION:
After replacing PHV cable with new one, oper-
ate clutch pedal about 30 times as a running-in
operation prior to adjustment.
8) Install air cleaner case. (Non-turbo model)
<Ref. to IN(SOHC)-7, REMOVAL, Air Cleaner
Case.>
9) Install intercooler. (Turbo model) <Ref. to
IN(DOHC TURBO)-10, INSTALLATION, Inter-
cooler.>
2. PHV CABLE
1) Install PHV cable in the reverse order of
removal.
S4M0245B
CAUTION:
¼ If cable clamp is damaged, replace it with a
new one.
¼ Avoid sharp bending of PHV cable as it may
cause breakage.
2) Apply grease to the following points.
¼ Hook portion of return spring
¼ Cable end portion of lever
BR-52
S405661A11
PHV cable. <Ref.
S405661A1102
S405661A1101
to BR-53