Subaru 2001 FORESTER Service Manual page 32

D: ASSEMBLY
S405172A02
1) Clean caliper body interior using brake fluid.
2) Apply a coat of brake fluid to piston seal and fit
piston seal in groove on caliper body.
3) Apply a coat of brake fluid to the entire inner
surface of cylinder and outer surface of piston.
4) Insert piston into cylinder.
CAUTION:
Do not force piston into cylinder.
5) Apply a coat of specified grease to boot and fit
in groove on ends of cylinder and piston.
Grease:
NIGLUBE RX-2 (Part No. 003606000)
6) Install the piston boot to the caliper body, and
attach boot ring.
(1) Piston boot
(2) Boot ring
(3) Piston seal
(4) Caliper body
7) Apply a coat of specified grease to guide pin,
outer surface, sleeve outer surface, cylinder inner
surface, and boot grooves.
Grease:
NIGLUBE RX-2 (Part No. 003606000)
(1) Pin boot
(2) Lock pin or guide pin
(3) Apply grease.
8) Install guide pin boot on caliper body.
9) Install lock pin boot on caliper body and insert
lock pin sleeve into place.
REAR DISC BRAKE ASSEMBLY
S4M0448A
B4M1176B
BR-31
E: INSPECTION
NOTE:
Repair or replace faulty parts.
1) Check caliper body and piston for uneven wear,
damage or rust.
2) Check rubber parts for damage or deterioration.
Brake
S405172A10