Installing The Vga Module - Dell Storage NX3330 Owner's Manual

Figure 44. Removing the VGA Module
1 screw
3 VGA module
Related links
Safety instructions
Before working inside your system

Installing the VGA module

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage
due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
NOTE: This procedure applies only to the eight hard drive system.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Keep the Philips #2 screwdriver ready.
Steps
1 Push the VGA module into the chassis and align the threaded screw hole on the VGA module with the screw hole on the chassis.
2 Replace the screw (at the bottom of the chassis) that secures the VGA module to the chassis.
3 Replace the control panel.
4 Connect the VGA module cable to the VGA module.
CAUTION: The display module connector is a ZIF (zero insertion force) connector. Ensure that the locking tab on the
connector is released before removal and insertion. The locking tab must be engaged after insertion.
5 Connect the display module cables to the control panel board.
102 Installing and removing system components
2 VGA module cable
4 control panel