Installing A Power Supply And Cooling Module - Dell EqualLogic PS4110 Hardware Owner's Manual

Hardware Owner's Manual 4 Maintaining Power Supply and Cooling Modules
Figure 24: Removing a Power Supply and Cooling Module

Installing a Power Supply and Cooling Module

To install a power supply and cooling module, use the following steps and illustrations:
1. Hold the power supply module so that the orange release latch is on the upper left.
2. Slide the power supply and cooling module into the chassis until it is fully seated and the release latch clicks
into place, as illustrated below.
Note: Before the power cable is connected, the fans start spinning, powered by the other power supply
module.
36