3
Press the touch points on the card until the card connector is firmly seated on the system board connector.
4
Tighten the captive screws to secure the NDC to the system board.
Figure 29. Installing the NDC
1
captive screw socket (2)
3
captive screw (2)
5
network daughter card (NDC)
Next steps
1
If applicable, install the expansion card(s) in the expansion card riser 2.
2
Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
After working inside your system
Processors and heat sinks
Use the following procedures when:
•
Removing and installing a heat sink
•
Installing an additional processor
•
Replacing a processor
NOTE:
To ensure proper system cooling, you must install a processor blank in any empty processor socket.
2
connector on the system board
4
touch point (2)
6
back panel slot for Ethernet connectors
Installing and removing system components
83