Hard Disk Drive Backplane - Dell Storage NX3330 Owner's Manual

CAUTION: To avoid damage to the battery connector, you must firmly support the connector while installing or
removing a battery.
2 Place your finger between the securing tabs at the negative side of the battery connector, and lift the battery out of the socket.
Figure 37. Removing the system battery
1 system battery
3 To install a new system battery, hold the battery with the "+" facing up and slide it under the securing tabs.
4 Press the battery into the connector until it snaps into place.
Figure 38. Installing the system battery
1 system battery
Next steps
1 Install the cooling shroud.
2 Follow the procedure listed in the After working inside your system section.
3 While booting, press F2 to enter System Setup and ensure the battery is operating properly.
4 Enter the correct time and date in the System Setup Time and Date fields.
5 Exit System Setup.
Related links
Safety instructions
Before working inside your system
Jumpers and connectors
After working inside your system

Hard disk drive backplane

The Dell Storage NX3330 system supports 2.5 inch (x4) SAS/SATA backplane.
94 Installing and removing system components
2 system battery slot
2 system battery slot