Installing A Control Module - Dell Equallogic PS6000 Hardware Maintenance

PS6000 Hardware Maintenance
Figure 3-5: Removing a Control Module
3. Place the control module on a flat surface where it will be protected from
electrostatic charge.
Caution: To avoid damage, do not place anything on top of the control module.
4. If you are replacing a failed control module, remove the micro SD card from
the failed control module as described in Replacing the Micro SD Card on
page 3-14 and install it in the replacement control module. This will make
sure that the new control module is running the correct firmware.
To install a replacement control module, see Installing a Control Module on
page 3-11. Do not operate an array with an empty control module slot.
When you replace a failed control module, return the module in the packaging in
which the replacement module was shipped. Contact your PS Series support
provider for information about returning hardware.

Installing a Control Module

You can install a control module without shutting down the array.
Caution: Do not mix control module types in a PS6000 array.
Maintaining Control Modules
3–11