Psus - Dell Storage NX3330 Owner's Manual

Figure 32. Installing a processor
1 socket-release lever 1
3 processor
5 processor shield
7 processor socket
Next steps
NOTE: Ensure that you install the heat sink after you install the processor. The heat sink is necessary to maintain proper thermal
conditions.
1 Install the heat sink.
2 If removed, reinstall the PCIe expansion card riser.
3 If disconnected, reconnect the cables to the expansion card(s).
4 Install the cooling shroud.
5 Follow the procedure listed in the After working inside your system.
6 While booting, press F2 to enter System Setup and verify that the processor information matches the new system configuration.
7 Run the system diagnostics to verify that the new processor operates correctly.
Related links
Safety instructions
Before working inside your system

PSUs

Your system supports one of the following:
• Two 750 W AC PSU modules or
88 Installing and removing system components
2 pin–1 corner of the processor
4 slot (4)
6 socket-release lever 2
8 tab (4)