Installing Control Panel-8 Hdd System - Dell Storage NX3330 Owner's Manual

CAUTION: Applying excessive force while pulling upward may damage the control panel.
3 Hold the top edge of the control panel at the corners and pull upward until the control panel tabs are released.
4 Hold the right edge of the control panel and rotate it toward the left until it is released from the chassis.
5 Pull the control panel away from the chassis.
Figure 43. Removing and installing the control panel
1 control panel
3 display module ZIF connector
Related links
Safety instructions
Before working inside your system
Installing control panel–8 HDD system
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage
due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
Keep the #1 Philips screwdriver ready.
Steps
1 Slide the left side of the control panel into the chassis so that the left tab on the control panel aligns with the slot on the chassis wall
and the top left tab aligns with the slot on the top of the chassis.
2 Pull the display module cable through the opening and into the chassis.
3 Push the right side of the control panel until the top right tab aligns with the top of the chassis and the panel snaps into place.
4 Using a #1 Philips screwdriver, replace the screw (located at the bottom of the chassis) that secures the control module to the
chassis.
100 Installing and removing system components
2 notch on chassis front wall (2)
4 display module cable