2723/#9723 Pci Ethernet Ioa (10 Mbps); 2815 Pci 155 Mbps Unshielded Twisted Pair Atm Ioa - IBM i series Handbook

iSeries Model 250 Packages and AS/400e Server 250
This feature provides a single attachment to either 16 Mbps or a 4 Mbps Token-Ring. The
feature consists of an IOA card, internal code that supplies IEEE 802.5 Media Access Control
(MAC) and IEEE 802.2 Logical Link Control (LCC) functions. The IOA is capable of operating
in half or full duplex mode.
The #2724/#9724 comes with an 2.44m Token-Ring cable, or a separately purchased
twisted-pair cable to the RJ45 connection on the IOA may be attached. It occupies one PCI
card slot.
If the #2724/#9724 16/4 Mbps Token-Ring LAN IOA is installed on an #2866 Integrated
Netfinity Server, then one Specify #0220 (Token-Ring on Integrated Netfinity Server) is
required for each #2724/#9724 ordered.
The #9724 is mutually exclusive with #9723 and #9738 as a base LAN controller.

#2723/#9723 PCI Ethernet IOA (10 Mbps)

The #9723 is a base LAN option on the Model 250.
This feature provides a single attachment to one Carrier Sense Multiple Access/Collision
Detect Local Area Network. It consists of an adapter card and internal code, which supplies
Ethernet Version 2 and IEEE 802.3 Media Access Control (MAC) plus 802.2 Logical Link
Control (LLC) functions. The Ethernet/IEEE 802.3 IOA is capable of operating in half or full
duplex mode.
The #2723/#9723 has an RJ45 connector and a 15-pin D-shell connector for attachment of
customer-supplied cabling. A vendor AUI Ethernet cable or RJ45 twisted-pair cable must be
ordered separately. RJ45 cabling for 10 Mbps must be CAT-3 or CAT-5, if CAT 5 is used, because
then it meets or exceeds Industry Standard EIA/TIA T568A or T568B. It occupies one PCI card
slot.
If #2723/#9723 Ethernet IOA is selected to be run on an #2866 Integrated Netfinity Server,
one Specify #0221 (Ethernet on Integrated Netfinity Server) is required for each #2723/#9723
ordered.
The #9723 is mutually exclusive with #9724 and #9738 as a base LAN controller.

#2815 PCI 155 Mbps Unshielded Twisted Pair ATM IOA

This feature allows the AS/400 system to be attached to an Asynchronous Transfer Mode
(ATM) network using the Unshielded Twisted Pair (UTP-5) interface. This interface is intended
for connection to both local area switches and direct connection to service provider
equipment. The #2815 is typically used where 155 Mbps speeds are required over distances
of less than 100 meters. It uses one high-speed slot, but cannot be placed in the Base
System Unit. It attaches in slot E08 and slot E03 (where #2824 is a prerequisite) of the
104
iSeries Handbook