Bit Switches
• Do not adjust a bit switch or use a setting that is described as "Not used", as this may cause the
machine to malfunction or to operate in a manner that is not accepted by local regulations. Such
bits are for use only in other areas, such as Japan.
• Default settings for bit switches are not listed in this manual. Refer to the System Parameter List
printed by the machine.
System Switches
System Switch 00 [SP No. 1-101-001]
No
FUNCTION
Dedicated transmission parameter
programming
0
0: Disabled, 1: Enabled
1
Not used
Technical data printout on the
Journal
2
0: Disabled
1: Enabled
COMMENTS
Set this bit to 1 before changing any dedicated
transmission parameters.
Reset this bit to 0 after programming dedicated
transmission parameters.
Do not change
1: Instead of the personal name, the following data are
listed on the Journal for each G3 communication.
Bit Switches
193