Ricoh D127 Field Service Manual page 368

4. Appendix: Fax Troubleshooting Guide
Code Meaning
Modem training fails even G3
0-05
shifts down to 2400 bps.
The other terminal did not
0-06
reply to DCS
No post-message response
0-07 from the other end after a
page was sent
160
Suggested Cause/Action
• Check the line connection.
• Try adjusting the tx level and/or cable equalizer.
• Replace the FCU.
• Check for line problems.
Cross reference
See error code 0-04.
• Check the line connection.
• Try adjusting the tx level and/or cable equalizer
settings.
• Replace the NCU or FCU.
• The other end may be defective or incompatible; try
sending to another machine.
• Check for line problems.
Cross reference
See error code 0-04.
• Check the line connection.
• Replace the NCU or FCU.
• The other end may have jammed or run out of paper.
• The other end user may have disconnected the call.
• Check for a bad line.
• The other end may be defective; try sending to
another machine.