Ricoh D127 Field Service Manual page 49

Paper Tray Unit Heater
12. Attach the heater harness (Long) [12] to the connector [13] on the board.
13. Attach the clamp (Large) [14]
14. Lead the heater harness (Long) [12] through the clamp (Large) [14] toward inner side of the copier
as shown.
15. Attach the clamp (Large) [15].
16. Pass the heater harness through the hole [16] to the rear of the copier.
17. Attach the grounding wire (Long) [17] ( x 1, Washer x1, Spring washer x1).
18. Pass the grounding wire (Long) [17] through the hole [16] to the rear of the copier.
19. Mount the copier on the paper tray unit [18].
20. Put the heater harness (Long) in the hole [19].
47