Ricoh D127 Field Service Manual page 50

2. Installation
• Be sure to put the heater harness (Long) in the hole on keeping the end of the heater harness (Long)
horizontally long. This makes insertion easy.
21. Pass the support bracket between the copier and the heater harness (Long) on keeping the end of
the heater harness (Long) in the hole.
• To do step 21 easily, be sure not to pass the heater harness (Long) completely thorough the hole
[19] at the step of 20.
22. Attach the edge saddle [20] to the support bracket.
23. Attach the heater harness (Long) and the grounding wire (Long) through the edge saddle as shown.
24. Pass the grounding wire (Long) through the hole.
25. Pull the heater harness (Long) and the grounding wire (Long) to the paper tray unit side.
26. Attach the grounding wire (Long) [21] (
27. Attach two of the clamps (Mid) [22] [23].
28. Attach the clamp (Mid) [24].
29. Connect the heater harness (Long) to the heater harness (Short).
30. Attach the heater harness through the clamps as shown.
• Be sure to make the bind attached on the heater harness upper than the clamp (Mid) [22] [24].
48
x 1, Washer x1, Spring washer x1)