Ricoh D127 Field Service Manual page 55

Paper Tray Unit Heater
13. Attach the heater harness (Long) [13] to the connector [14] on the board.
14. Attach the clamp (Large) [15]
15. Lead the heater harness (Long) [13] through the clamp (Large) [15] toward inner side of the copier
as shown.
16. Attach the clamp (Large) [16].
17. Pass the heater harness through the hole [17] to the rear of the copier.
18. Attach the grounding wire (Long) [18] ( x 1, Washer x1, Spring washer x1)
19. Pass the grounding wire (Long) [18] through the hole [17] to the rear of the copier.
20. Mount the copier on two of the paper tray units [19].
21. Put the heater harness (Long) in the hole [20].
53