Change Password - Fiery X2 Administrator's Manual

2
2-47 Administrative functions in the Setup menu

Change Password

Clear Server
Setup
Remove Calibration
Choose Remove Calibration when you wish to return the copier to its default state.
You do not need to remove a calibration before applying a new calibration.
This affects all users. Continue?
Yes/No [Yes]
This option is a reminder that calibration is a global setting; if you remove calibration,
every print job is affected by your action.
If you choose , the current calibration is removed and you return to the main Cali-
Yes
bration screen. If you are finished, choose
If you choose No , the calibration is not removed, but you still return to the main Cali-
bration screen.
Exit Calibration
When you choose
Exit Calibration
Change Password
Change Password enables you to set or change the Administrator password for the
Fiery X2. This password determines whether a user can modify the Setup options. See
page xiv for information on Administrator access privileges.
When the Fiery X2 is installed, there is no password. If you do not create an Adminis-
trator password, users are not required to enter a password to modify the Setup. If an
Administrator password has been set previously, you are required to enter it when you
run Setup. Use the up and down button to select the characters and the left and right
arrow buttons to move between them (see page 2–7).
Scroll to the third screen of the main Setup menu to choose
Enter and confirm the password as described below.
New Password
Use the up and down buttons to select the characters and the left and right arrow
buttons to move between them. Enter characters from left to right, since the left arrow
line selection button is a delete key. The password can be any combination of letters
. The Fiery X2 reboots.
Exit Calibration
, the Fiery X2 reboots.
Change Password .