Before You Begin - Fiery X2 Administrator's Manual

1
1-11 Fiery X2 on the network

Before you begin

The following steps should be completed before you configure the Fiery X2 and the
workstations that will print to the Fiery X2. A service technician will have performed
some initial installation.
T F X2
O PREPARE FOR IERY
1. Print a copier test page to make sure the copier is functioning normally.
2. Turn off the copier and connect the interface cable from the copier to the
Fiery X2.
3. To confirm this connection, turn on the copier and the Fiery X2 and print a Test Page
from the Control Panel.
To print a Test Page, press the Menu button on the Control Panel to display the
Functions menu. (See "Fiery X2 Setup from the Control Panel" on page 2-2.) Choose
Print Pages, and then Test Page.
4. With both the copier and the Fiery X2 turned off, connect the network cable to the
Fiery X2, as described in the next section.
The network should already be installed and operational.
5. Turn on the copier and then the Fiery X2.
6. Prepare network servers to share Fiery X2 user software and to enable networked users
to print to the Fiery X2, and proceed to Setup.
See Chapters 2 and 3 for details.
:
CONFIGURATION