Table of Contents
Advertisement
2
2-15 Network Setup options
Exit Protocol Setup
AppleTalk Setup
TCP/IP Setup
IPX/SPX Setup
Protocol Setup
Network Setup
Protocol Setup
Ignore EOF Character
Yes/No [No]
This option appears only if
the Fiery X2 should ignore end-of-file (EOF) messages in a file. This option must be
set to
to print PostScript files in binary format (not ASCII); under normal circum-
Yes
stances, it should be set to
No
allel port timeout value to determine when the end of the file has been reached.
When you have configured the port options, choose another port type, or choose Exit
Port Setup and proceed to Protocol Setup.
Protocol Setup options
To configure the Fiery X2, choose each protocol and enter the settings for that
protocol. You can enable AppleTalk, TCP/IP, and IPX/SPX communication
simultaneously.
AppleTalk Setup
Enable AppleTalk
Yes/No [Yes]
Select
if you have an AppleTalk network connected to the Fiery X2. This
Yes
setting enables the Fiery X2 to communicate over AppleTalk networks.
AppleTalk Zone
List of zones
The Fiery X2 searches the network for AppleTalk zones in your network segment.
Scroll through the list to select the AppleTalk zone in which you want the Fiery X2 to
appear. If your segment has only one zone, the Fiery X2 is assigned to that zone auto-
matically.
The message "No AppleTalk zone found" may mean your network has no zones, or the
network cable is not connected (see page 4-4). Choose OK.
Enable Parallel Port
is set to
. When this option is set to
Yes
. This option specifies that
, the Fiery X2 uses the par-
Yes
Advertisement
Table of Contents
