Port Setup Options - Fiery X2 Administrator's Manual

2
2-13 Network Setup options
Exit Port Setup
Ethernet Setup
Token Ring Setup
Parallel Port Setup
Port Setup
Network Setup
Port Setup
Network Setup
Port Setup

Port Setup options

You can enable Ethernet and parallel communication simultaneously. If the Token
Ring option is installed, you can also enable Token Ring. To configure the Fiery X2,
choose each port type you use and enter the settings for that port. Since network
setups are nested, the names of higher-level menus are shown in this chapter to the
left of each menu heading.
Ethernet Setup
Enable Ethernet
Yes/No [Yes]
Select Yes if you have Ethernet cabling connected to the Fiery X2.
Ethernet Speed
Auto Detect/100 Mbps/10 Mbps [Auto Detect]
Select if your network environment is mixed, or if you do not know the
Auto Detect
network speed. If you know the speed of the network to which the Fiery X2 is
attached (10 Mbps or 100 Mbps), select it.
Token Ring Setup
Enable Token Ring
Yes/No [No]
Select if the Fiery X2 is to be connected to a Token Ring network.
Yes
Token Ring Speed
Auto Detect/16 Mbps/4 Mbps [Auto Detect]
Select Auto Detect if your network environment is mixed, or select the speed
(4 Mbps or 16 Mbps) of the network to which the Fiery X2 is attached.
Maximum Frame Size
(bytes)
4202/2154/1130/632 [4202]
Select the maximum frame size recommended by the network administrator at your
site. If you are uncertain of the setting to use, select the default value (4202).