Configuring A Windows Nt 4.0 Server To Support The Fiery X2 - Fiery X2 Administrator's Manual

4
4-19 Configuring a Windows NT 4.0 server to support the Fiery X2
Configuring a Windows NT 4.0 server to support
the Fiery X2
To configure a Windows NT 4.0 server to communicate with the Fiery X2, follow
these general steps. More detail is provided in subsequent sections.
• Load the TCP/IP network protocol (see the next section).
• Enter the host name of the Fiery X2 in the host database used by your system (see
page 4-20).
• On the Fiery X2 Control Panel, perform Server Setup (see page 2-8), Network Setup
(page 2-10), Printer Setup (page 2-36), PS Setup (page 2-38), and Color Setup
(page 2-40).
• On the Windows NT 4.0 server, create a printer for each Fiery X2 queue, install the
appropriate printer drivers (if necessary) and (optionally) share the printer on the
network (see page 4-22).
• Enter the host name and remote printer name of the Fiery X2 in the printer connec-
tion. See page 4-27 for more information.
• If the Windows NT 4.0 server is also a workstation, install the Fiery utilities (see
Getting Started and page 4-24).
T TCP/IP
O ADD NETWORK SERVICES
1. Log in to the Windows NT 4.0 server as Administrator.
2. In the Control Panel, double-click the Network icon.
The Network Settings dialog box appears.
3. Click the Services tab, and click Add.
4. In the Select Network Service dialog box, select Microsoft TCP/IP Printing and click
OK.
5. In the Windows NT Setup dialog box, specify the location of your Windows NT 4.0 soft-
ware files and click Continue.
Insert your Windows NT 4.0 system software CD and specify the CD-ROM drive's
volume; or, if the files reside on your hard drive or on the network, specify the appro-
priate path.
: