Using Setup; Getting Help; In Case Of Problems; A Final Note About Setup - Contec EPC-2020 Series User Manual

Using Setup

In general, you use the arrow keys to highlight items, press <Enter> to select, use the "+" and "-" keys to
change entries, press <F1> for help and press <Esc> to quit. The following table provides more detail
about how to navigate in the Setup program using the keyboard.
Table 5.1. Using Setup
Key
Up Arrow Move to the previous item
Down Arrow Move to the next item
Left Arrow Move to the item on the left (menu bar)
Right Arrow Move to the item on the right (menu bar)
Enter Move to the item you desired
+
Increase the numeric value or make changes
Decrease the numeric value or make changes
－
F1 General help on Setup navigation keys
F2 Load previous settings
F3 Load the optimized defaults
F4 Save all settings changes to the FLASH ROM and exit
Main Menu: Quit without saving changes
ESC
Submenus: Exit Current page to the next higher level menu

Getting Help

Press F1 to pop up a small help window that describes the appropriate keys to use and the possible
selections for the highlighted item. To exit the Help Window press <Esc> or the F1 key again.

In Case of Problems

If it is not possible to boot the computer after system settings have been changed and saved during setup,
this product will need to be repaired.
The best advice is to only alter settings which you thoroughly understand. To this end, we strongly
recommend that you avoid making any changes to the chipset defaults. These defaults have been carefully
chosen by both AMI and your systems manufacturer to provide the absolute maximum performance and
reliability. If chipset settings are changed even slightly, it may become necessary to repair the unit.

A Final Note About Setup

The information in this chapter is subject to change without notice.
EPC-2020 Series User's manual
Function
5. BIOS Setup
29