Table of Contents
Advertisement
6. Software RAID setup
About the Product
This chapter describes software mirroring (RAID1) setup. We only support mirroring. We do not support
operation for other RAIDs (RAID0, RAID5, and RAID10). Be aware that functions not supported are
outside the scope of the warranty.
Software RAIDs are not hot-swappable.
CAUTION
If RAID settings are changed, all data on the hard disks will be erased.
Back up necessary data in advance.
Starting the setup screen
Before starting the RAID utility, set the IDE device to RAID in the BIOS setup described in Chapter 3.
Press the <CTRL> and <I> keys on the following screen to start the RAID utility. After a few seconds,
the RAID utility can be started.
Intel(R) Rapid Storage Technology - Option ROM - 10.5.0.864
Copyright(C) 2003-11 Intel Corporation. All Right Reserved.
RAID Volumes:
ID
Name
Physical Disks:
Port Drive Model Serial #
*
*********** *************
*
*********** *************
Press <CTRL-I> to enter Configuration Utility.
CAUTION
If the IDE device is not set to RAID in the BIOS setup, the above screen will not appear.
Note
The information in this chapter may be changed without notice.
EPC-2020 Series User's manual
Level
Strip
Size
Size
***GB Non-RAID Disk
***GB Non-RAID Disk
Status
Bootable
Type/Status(Vol ID)
6. Software RAID setup
71
Advertisement
Table of Contents
