Table of Contents
Advertisement
Introduction
CAUTION
-
Do not use or store this product in a location exposed to high or low temperature that exceeds range
of specification or susceptible to rapid temperature changes.
Example:
-
Do not use this product in extremely humid or dusty locations. It is extremely dangerous to use this
product with its interior penetrated by water or any other fluid or conductive dust. If this product
must be used in such an environment, install it on a dust-proof control panel, for example.
-
Avoid using or storing this product in locations subject to shock or vibration that exceeds range of
specification.
-
Do not use this product in the vicinity of devices that generate strong magnetic force or noise. Such
products will cause this product to malfunction.
-
Do not use or store this product in the presence of chemicals.
-
To clean this product, wipe it gently with a soft cloth dampened with either water or mild detergent.
Do not use chemicals or a volatile solvent, such as benzene or thinner, to prevent pealing or
discoloration of the paint.
-
Continuously operating the product may decrease the service life of the hard disk drive, so use the
standby mode.
-
Always disconnect the power cable from the receptacle before mounting or removing the expansion
board, or before connecting or disconnecting any connector.
-
CONTEC reserves the right to refuse to service a product modified by the user.
-
In the event of failure or abnormality (foul smells or excessive heat generation), unplug the power
cord immediately and contact your retailer.
-
Use an AC cable that matches the power supply voltage and outlet plug that you are using. (The
included cable is designed for use with a 125 VAC power supply.)
-
Component Life:
Battery---The internal calendar clock and CMOS RAM are backed by a Lithium primary battery.
The backup time at a temperature of 25°C with the power disconnected is 7 years.
* Replacement of expendables is handled as a repair (there will be a charge).
-
To connect with peripherals, use a grounded, shielded cable.
-
Do not use a UPS (Uninterruptible Power Supply) that generates square waves. Connecting the
product to this type of UPS may lead to product failure.
-
Replacing the battery with an inappropriate type of battery may lead to explosions. Dispose of used
batteries according to the instructions in the instruction manual.
-
When disposing of a used battery, follow the disposal procedures stipulated under the relevant laws
and municipal ordinances.
-
If using this product in an environment that is subject to noise, attach a ferrite core to each signal
cable (LAN, USB, serial, analog RGB, HDMI, and line input).
4
- Exposure to direct sun
- In the vicinity of a heat source
EPC-2020 Series User's manual
Advertisement
Table of Contents
