Hardware Setup; Installing The Internal Cfast Card - Contec EPC-2020 Series User Manual

Hardware Setup

Hardware Setup
- Before you start, be sure that the power is turned off.
- Remove only those screws that are explained. Do not move any other screw.

Installing the Internal CFast Card

(1) Remove the screw from the panel, which is being held in place by the said screw, on the base of the
main unit.
(2) Remove the panel.
(3) Insert the CFast card into the main unit.
Figure 3.1. Installing the CFast Card
(4) I screwed the bottom panel.
CAUTION
If you use a CFast card other than the optional card, we cannot guarantee the specifications of this
product. If you want to use the product within its specifications, be sure to use the optional CFast
card.
The specified tightening torque is 5 - 6kgf⋅cm.
14
EPC-2020 Series User's manual