Installing Hdds - Contec EPC-2020 Series User Manual

Installing HDDs

You can equip the product with slot-in type 2.5-inch SATA HDDs.
(1) Loosen the HDD case screws on the front of the product, and then pull out the case.
Figure 3.2. Removing the HDD case
(2) Use screws to fix the HDD in place inside the HDD case with the HDD label facing up.
Screw
Figure 3.3. Installation of HDD
CAUTION
Please note the mounting direction of the HDD.
The specified tightening torque is 2.5±0.2 kgf･cm.
EPC-2020 Series User's manual
Label
SATA connector side
Hardware Setup
15