Power-On Inspection; Figure 2-1 Connect The Power Cord; Figure 2-2 Power-On Inspection - Rigol DS1102E Service Manual

Chapter 2 Prepare for Use

Power-On Inspection

Generally, normal operating voltage and frequency for DS1000E, DS1000D series
digital oscilloscope are 100-240V
terminal of the power cord to the socket in left side of the oscilloscope and the other
to the AC power source.
Press the power button on top of the oscilloscope, some keys on the front panel will
light for about 2 seconds until the normal display appears. And then you can operate
the oscilloscope.
WARNING
!
To avoid the electric shock, make sure the oscilloscope is under good
grounding before connecting AC power.
After power-on, the oscilloscope performs all the self-testing automatically. Then,
press Storage and select Storage to recall the Factory settings after passing test (the
screen will appear).
Power button
Service Guide for DS1000E, DS1000D Series
and 45-440Hz respectively. Please connect one
RMS

Figure 2-1 Connect the power cord

Figure 2-2 Power-on inspection

RIGOL
Storage button
2-3