Installing 12900E Lpus - HP FlexFabric 12900E series Installation Manual

Figure 22 Installing a 12900 LPU (12916E switch)
(1) Push the LPU slowly along the guide rails into the slot
(3) Push the LPU by the middle part on the front panel
(5) Fasten the captive screws on the LPU

Installing 12900E LPUs

The 12900E LPUs available for the switch have a height of 50 mm (1.97 in), a width of 433 mm
(17.05 in), and a depth that varies by LPU model. No interface module adapter is required to install a
12900E LPU on the switch.
The 12900E LPU ejector levers and the ejector lever seats on the LPU slots have purple marks.
To install a 12900E LPU:
As shown by callout 1 in
1.
Keep the removed filler panel secure for future use.
Figure 23, remove the filler panel from the target LPU slot.
33
(2) Pull the ejector levers outward
(4) Pull the ejector levers inward