Repacking The Switch Chassis - HP FlexFabric 12900E series Installation Manual

Remove the switching fabric module slot filler panel. For more information, see
2.
procedures."
Place the removed switching fabric module slot filler panel in the packing bag.
3.
Place the foam cushion over the packing bag.
4.
Place the switching fabric module slot filler panel and the foam cushion in the packing box, and
5.
seal the box with tape.
Perform the same steps to repack the other switching fabric module slot filler panels.
6.

Repacking the switch chassis

Removing the chassis from the rack
The switch is heavy. Use a mechanical lift to move the switch.
To remove the chassis from the rack:
Prepare the wooden pallet base, carton, and packing bag of the chassis. Make sure they are
1.
clean, dry, and not damaged.
Put the wooden pallet base to a proper place.
2.
As shown in callout 1 in
3.
the mounting brackets to the rack.
As shown in callout 2 in
4.
outwards along the slide rails. When most part of the chassis is removed from the slide rails, lift
up the chassis by holding the handles at the chassis sides to completely remove the chassis
from the rack.
Put the chassis onto the wooden pallet base.
5.
Figure 92 Removing the switch from the rack (12916E switch)
(1) Loosen the captive screws that attach the mounting brackets to the rack
(3) Slide the chassis out of the rack along the slide rails
Figure 92, use a Phillips screwdriver to loosen the screws that attach
Figure 92, cooperate with a minimum of four people to slide the chassis
137
"Replacement
(2) Chassis handles