Installing Mpus - HP FlexFabric 12900E series Installation Manual

Figure 17 Attaching an ESD wrist strap (12916E switch)
(1) ESD jack (with an ESD sign)

Installing MPUs

CAUTION:
• If you are not to install an MPU in an MPU slot, keep the filler panel in the slot.
• Before you install an MPU in the chassis, make sure the connectors on the MPU are not broken
or blocked.
• When you install an MPU, avoid damaging the connectors on the MPU.
For the compatibility between the switch and the MPUs, see
matrixes."
You can install one MPU, or two MPUs for redundancy on the switch. If you are to install one MPU,
install it in either of the MPU slots.
Installing MPUs for the 12916E and 12908E switches
For the 12916E and 12908E switches, the ejector levers of the MPUs and the ejector lever seats on
the MPU slots have pink marks. The MPU installation procedure is the same for the 12916E and
12908E switches. The following uses the 12916E switch as example.
To install an MPU:
"Appendix B FRUs and compatibility
28