HP FlexFabric 12900E series Installation Manual page 49

Figure 33 Using a self-adhesive cable tie to secure the power cord to the switch (12916E
switch)
Connecting the DC power cord
WARNING!
Make sure the circuit breakers for the terminals marked – and + are turned off.
To connect the DC power cord:
Connect the DC power cord connector to the DC input receptacle of the power supply.
1.
Fasten the screw on the connector to secure the connector to the receptacle.
2.
Connect the other ends of the wires to the DC power source wiring terminals, with the negative
3.
wire (– or L–) to the negative terminal (–) and the positive wire (+ or M/N) to the positive terminal
(+).
43