Repacking The Switch Chassis - HP FlexFabric 12900E series Installation Manual

Repacking the switch chassis

Align the left and right edges of the chassis bottom with the left and right positioning lines
1.
respectively on the wooden pallet base. See
Figure 93 Wooden pallet base
(1) Wooden pallet base
(3) Right positioning line
(5) Front of the base (same direction as the front panel of the chassis)
Use screws to attach L-type brackets to the chassis, as shown by callout 2 in
2.
Move the chassis so that the mounting holes on the horizontal ear of the L-type brackets align
3.
with the mounting holes on the wooden pallet base. Use screws to attach the L-type brackets to
the wooden pallet base, as shown by callout 3 in
Cover the chassis with the packing bag from the top down, and then tape the bag to the plastic
4.
cover of pallet base.
Erect one paper angle bead along each vertical edge of the chassis, and use the carton to cover
5.
the chassis from top down with the mark side facing the front panel of the chassis
Cover the foam cushion to the chassis top, and make sure the mounting brackets seat into the
6.
internal notches of the foam cushion. See callout 2 of
Fit the four boxes that contain the switching fabric module slot filler panels into the notches in
7.
both sides of the foam cushion.
Put the box of packed accessories into the notch of the foam cushion that is near to the rear end
8.
of the chassis, as shown in callout 3 of
Cover the top cap to the carton.
9.
Figure 93 for the wooden pallet base.
(2) Left positioning line
(4) Screw hole
Figure 94.
Figure
Figure 95.
138
Figure
95.
94.