HP FlexFabric 12900E series Installation Manual page 28

For the 12916E and 12908E switches, the name plate on the upper right corner of the front
panel covers two mounting screw holes in the mounting brackets. Screws are not needed for
these two mounting holes.
If the mounting holes in the mounting brackets cannot align with the cage nuts on the rack,
verify the following items:
The top flange of the slide rail aligns with the middle of the narrower metal area between
holes.
The cage nuts are installed in the correct holes.
Figure 12 Mounting the 12916E/12908E switch in the rack
2
(1) Chassis handle
(3) Use screws to secure the mounting brackets to the rack
1
22
3
(2) Slide the chassis into the rack
3