5.6
PROPANE FUEL FILTER REPLACEMENT
1. Electric Lock Off Solenoid
2. Mounting Plate
3. Housing Seal
4. Filter Magnet
5. Filter Housing
6. Seal
Figure 5-6. Filter Lock Assembly
3121641
SECTION 5 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
7. Electrical Connector
8. Fuel Outlet
9. O-ring
10. Filter
11. Fuel Inlet
12. Retaining Bolt
– JLG Lift –
Removal
1. Relieve the propane fuel system pressure. Refer to Sec-
tion 5.7, Propane Fuel System Pressure Relief.
2. Disconnect the negative battery cable.
3. Slowly loosen the filter housing retaining bolt and
remove it.
4. Pull the filter housing from the electric lock off assem-
bly.
5. Locate filter magnet and remove it.
6. Remove the filter from the housing.
7. Remove and discard the housing seal.
8. Remove and discard the retaining bolt seal.
9. Remove and discard mounting plate to lock off o-ring
seal
Installation
NOTICE
BE SURE TO REINSTALL THE FILTER MAGNET INTO THE HOUSING BEFORE
INSTALLING NEW SEAL.
1. Install the mounting plate to lock off O-ring seal.
5-21