Special Inspection Mode - Epson Artisan 810 Service Manual

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD

8.4.3 Special Inspection Mode

The capacitive touch panel is employed for Artisan 725/PX720WD/TX720WD,
therefore, the start-up method in the special inspection mode differs from that for the
others.
If an inspection for Artisan 725/PX720WD/TX720WD in the special inspection mode
is necessary, start the printer following the procedure below and then carry out the
inspection.
The start-up method in the special inspection mode for Artisan
C H E C K
P O I N T 835/PX820FWD/TX820FWD is the same as Artisan 810/
PX810FW/TX810FW.
The inspections necessary to start the printer in the special
inspection mode are as follows.
Case open sensor check
•
Touch panel operation check
•
When starting Artisan 725/PX720WD/TX720WD in the special
inspection mode, take the necessary procedure within 30
seconds after turning the power off. If 30 seconds or more pass
after turning the power off, turn it on once again, then turn it
back off and take the necessary procedure within 30 seconds to
start the printer in the special inspection mode.
Press the Power button to exit from the special inspection mode.
The following screen appears when the Power button is pressed,
and the power turns off if the button is kept pressed again.
Initial Charge Flag check
Initial Charge Flag: OFF
Inspection Mode Flag check
Inspection Mode Flag: OFF
Push [Power] button
Figure 8-28. Power Off Screen in the Special Inspection Mode
If one of the modes in the menu
entered by pressing the OK button, you cannot go back to the
screen (Fig. 8-30) again. To return to the screen
the power off once, and start the printer in the special inspection
mode once again.
Artisan 835/725/PX820FWD/TX820FWD/PX720WD/TX720WD
(p220)
(p279)
(Fig. 8-30) is selected and
(Fig. 8-30), turn
The start-up method in the special inspection mode for Artisan 725/PX720WD/
TX720WD
1. Press the Power button to turn on Artisan 725/PX720WD/TX720WD.
2. After the printer turns on normally, turn the power off once.
3. Within 30 seconds after turning the power off and the LCD screen goes off,
press and keep pressing the sections shown below (1), then press the Power
button for more than one second (2) to start Artisan 725/PX720WD/
TX720WD in the special inspection mode.
(2) Press this for more than one sec.
Figure 8-29. Starting the Special Inspection Mode
(Artisan 725/PX720WD/TX720WD)
4. When turning the printer on in the special inspection mode, the following
screen appears on the LCD. Take the necessary inspection.
Inspection Mode
1. Mechanism Inspection
2. Special Inspection
3. Development Mode
4. Normal Mode
Figure 8-30. Start-up Screen in the Special Inspection Mode
(Artisan 725/PX720WD/TX720WD)
Adjustment
(1) Keep pressing these
Run: OK / Select: [UP] [DOWN]
Revision G
278
Confidential