Panel Unit - Epson Artisan 810 Service Manual

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
8. While lifting the Upper Housing, pull out the Panel FFC from the hole of the
Upper Housing and remove the Upper Housing.
Upper Housing
Panel FFC
Figure 8-12. Removing the Upper Housing (5)
9. Remove the Panel Unit from the Upper Housing. (See
Step8 (p269) and after.)
Tighten the screws in the order shown in
Secure the Panel FFC and ferrite core to the Panel Shield Plate
with double-sided tape. (See
Fold the Panel FFC at the fold line, and route it along the
marking on the Panel Shield Plate.
Figure 8-13. Routing the Panel FFC
After removing/replacing the Upper Housing, make the specified
A D J U S T M E N T
R E Q U I R E D
adjustments. (See 8.4 "Adjustment"
Artisan 835/725/PX820FWD/TX820FWD/PX720WD/TX720WD

Panel Unit

Hole of Upper Housing
8.3.2.3 Panel Unit
Fig. 8-10.
Fig. 8-9 (p267).)
Marking
(p274).)
Disassembly/assembly
8.3.2.3 Panel Unit
This section describes the disassembly/reassembly procedures of the
C H E C K
Panel Unit for Artisan 725/PX720WD/TX720WD.
P O I N T
The disassembly/reassembly procedures for Artisan 835/
PX820FWD/TX820FWD are the same as those for Artisan 810/
PX810FW/TX810FW, therefore, see
the procedures.
Parts/Components need to be removed in advance:
Scanner Unit/Upper Left Housing/Paper Guide Top Assy
Removal procedure
1. Remove the screw (x1) and release the grounding wire. (See
Housing Step1 (p266).)
2. Open the Panel Unit. (See Fig. 8-8
3. Release the hook (x1) on the rear of the Panel Unit, and remove the Panel
Rear Cover. (See 8.3.2.2 Upper Housing Step3
4. Peel off the Panel FFC and the ferrite core that are secured to the Panel Shield
Plate with the double-sided tape, and disconnect the Panel FFC from the
connector on the Panel Unit. (See
5. Pull out the ferrite core from the Panel FFC. (See
Step5 (p267).)
6. Remove the screws (x2) that secure the Right Hinge.
Panel Unit
Figure 8-14. Removing the Panel Unit (1)
Revision G
4.2.4.1 "Panel Unit" (p124)
8.3.2.2 Upper
(p267).)
(p267).)
8.3.2.2 Upper Housing Step4 (p267).)
8.3.2.2 Upper Housing
Right Hinge
C.B.P. 3x10 (black) (6±1Kgfcm)
Confidential
for
268