Mac Address Setting - Epson Artisan 810 Service Manual

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD

5.2.6 MAC Address Setting

Overview
This printer have a network function and stores there MAC address (Media Access
Control Address) in the EEPROM on the Network Board. The Network Board supplied
as an ASP does not come with the MAC address written on it, therefore, you are
required to set the MAC address to the new Network Board after replacement. The
following explains the procedure.
To avoid a conflict of MAC address on a network, make sure to
C A U T I O N
correctly follow the MAC address setting flowchart given on
the right.
The MAC Address is written correctly, The IP Address will be
initialized also.
The user should be notified of the change of MAC address
because of the following reasons.
If the user has set the printer's MAC address on a router, the
"
repaired printer with a new MAC address cannot be
connected to the network.
" The default printer name on a network consists of "EPSON"
and the last six digits of the MAC address. Therefore, the
printer name becomes different from the previous one.
For Artisan 835/725/PX820FWD/TX820FWD/PX720WD/
TX720WD, the MAC address label is not supplied as an ASP
because the servicing which needs its replacement has almost
never occurred.
Preparation
When replacing the Network Board, make sure to note down the MAC address written
on a label on the Upper M/B Shield Plate. If the address is not readable due to
contamination or any other cause, attach a new MAC address label (part code:
1489231) and note down the new address. See
M/B (p126) " for description about the label position.
ADJUSTMENT
"4.2.4.2 Main Board / Grounding Plate
Adjustment Using Adjustment Program
You are required to enter the last six digits of the MAC address
C H E C K
(xx:yy:zz) written on the MAC Address Label to the adjustment
P O I N T
program. First six digits are automatically selected from two kinds
by the adjustment program depending on the last six digits.
MAC address example:
00:00:48:xx:yy:zz or 00:26:AB:xx:yy:zz
("xx, yy, zz" represents a value unique to each printer)
Setting flowchart
START
Is the MAC address on
the label readable?
No
No
Replace the Network Board with a new one.
Attach a new MAC address label on the Upper M/
B Shield Plate.
Enter the new MAC address using the adjustment
program.
END
Figure 5-8. MAC Address Setting Flowchart
Revision G
Replace the Network Board with a
Yes
new one.
Enter the MAC address written on
the label using the adjustment
program.
END
Confidential
217