Epson Artisan 810 Service Manual page 138

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
8. Tighten the screws (x2) in the order shown in
thickness gauge.
Figure 4-65. Assembling the Printhead (5)
DISASSEMBLY/ASSEMBLY
Fig. 4-65 while holding the
Tighten the second screw while holding both
ends of the thickness gauge.
2
1
C.B.P. 2x10 (2.0±0.3Kgfcm)
Disassembly Procedures
9. To seal more reliably the joint between the Ink Supply Tube and the Printhead by
making the SEAL JOINT,H adhere more tightly, follow the steps below.
9-1. Mark the 0 digit side of the tightened screws (x2) in
or the like.
9-2. Loosen the marked screws by 180 degrees.
9-3. To make the gap even between the joint of the Printhead and the Ink
Supply Tube, move your finger to the right and then to the left while
pressing the side of the Ink Supply Tube shown in
the rear of the printer.
2) Loosen the marked
screws by 180 degrees.
3) Move your finger in the order shown below while pressing gently the part above
enclosed in the broken line to the rear. Make sure that the gap between the joint of
the Printhead and the Ink Supply Tube is even.
2
1
Figure 4-66. Assembling the Printhead (6)
Revision G
Step 8 with a felt pen
Fig. 4-66 gently toward
1) Mark this part with a felt pen
or the like.
Make this gap even.
138
Confidential