Epson Artisan 810 Service Manual page 273

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
Install the Ink System as follows:
1. When the Carriage Lock sticks out, rotate the Combination
Gear in the direction of the arrow to lower the Carriage Lock.
Carriage Lock
Porous Pad
Figure 8-24. Installing the Ink System (1)
2. Press the switch lever in the direction of the arrow and move the
Transmission Arm upward by rotating the Spur Gear to make a
room.
Spur Gear
Transmission Arm
Figure 8-25. Installing the Ink System (2)
Artisan 835/725/PX820FWD/TX820FWD/PX720WD/TX720WD
Ink System
Combination Gear
Switch lever
Transmission Arm
Transmission Arm
3. Align the dowels (x2) and the positioning hole (x1) of the Ink
System with the positioning holes (x2) on the Main Frame and the
dowel (x1) on the Transmission Holder Assy shown in
4. Align the dowel of the Ink System with the positioning hole on the
Main Frame. (See
Disassembly/assembly
Rubber seal,
head cleaner
Transmission Holder Assy
Figure 8-26. Installing the Ink System (3)
Fig. 8-22.)
(Continued to the next page.)
Revision G
Fig. 8-26.
Ink System
Dowel
Positioning hole
Dowel
Positioning hole
Position A
273
Confidential