Epson Artisan 810 Service Manual page 189

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
3. Tilt the Panel Unit by 45 degrees to align the rib of the shaft on the left side of
the Panel Unit with the groove of the Upper Housing.
Groove of the
Upper Housing
Rib of the shaft
Figure 4-179. Removing the Panel Unit (2)
4. Lift the Panel Unit so as not to let the Right Hinge interfere with the Upper
Housing, and remove the shaft from the bushing on the left side of the Panel
Unit, and then remove the Panel Unit.
Bushing
Panel Unit
Figure 4-180. Removing the Panel Unit (3)
DISASSEMBLY/ASSEMBLY
Right Hinge
Disassembly/reassembly procedures specific to Artisan 710/PX710W/TX710W
After replacing the Panel Unit, be sure to perform the required
A D J U S T M E N T
R E Q U I R E D lubrication. (See Chapter 6
Revision G
"MAINTENANCE".)
Confidential
189