Disarmed Notification; Two-Stage Disarm; Shock Sense Bypass; Resetting The Module - Autostart AS-6205 SH Installation Manual

Disarmed Notification

This feature will notify the user when the vehicle is left disarmed after Ignition is turned off, or
when the Module is disarmed after being previously armed, the opening or closing of a Door
will cause the Horn or the Siren to sound once after 10 sec. to warn the user that the vehicle
was left unprotected. Pressing

Two-Stage Disarm

When the Siren is sounding, pressing
disarming the vehicle. You can disable this feature by selecting corresponding option in the
Passive or Active Function.

Shock Sense Bypass

When is programmed for Trunk with Disarm/Rearm option, and the Trunk pin from the
AUX 3
vehicle has been connected to the Door Pin input wire (diode isolated), it is not necessary to
press on to disarm the Alarm prior to pressing the
UNLOCK
When the Trunk is opened by remote control, the Door Zone/"Trunk pin" will be ignored; the
Shock Sensor will also be ignored until the Door Zone/"Trunk pin" closes. Monitoring will
resume 5 seconds after the Door Zone (Trunk pin) is closed.

Resetting The Module

The system is equipped with a reset function that allows the installer to erase all Transmitter
codes and return all programmed Options to the factory default values.
To reset the Module:
1.
FLASH the Hood pin switch.
2.
Before the 20 seconds have passed, Press the Valet Button 6 times or more, until
the Parking Lights start to flash.
3.
The Parking Lights will flash 8 times confirming the Reset.

Events Logging

The Module will play back the last 4 Start Failure Events Codes and the last Intrusion Code
via the Parking Lights and L.E.D.

Events playback

Ensure that the Hood is up and that the Ignition is
Hold down the Hood Pin-switch for 4 seconds.
Release the Pin-switch.
The Parking Lights will come on.
With the Parking Lights on, immediately push the Pin-switch 3 times.
The Parking Lights and L.E.D. will flash the five events stored in memory.
The first four playback codes are Start Failure Events, while the last playback code is an
Intrusion Code. There is a pause after each event code is played back.
The system will play back the most recent event first, then the second most-recent, and so
on. If there are no events at all to report, the Parking Lights will give one long flash.
Start Failure Codes via Parking
Lights
1 x = No Start
3 x = Hardware Reset
P.18
or will cancel this timer.
LOCK UNLOCK
will stop the siren – but without unlocking or
UNLOCK
TRUNK
Table 12
.
OFF
4 x = Brakes
5 x = No Tach cut-off
6 x = Hood
7 x = Engine Running, no Ignition
detected, or Tach before Start
button.
Installation Guide AS-6205 SH