Table of Contents
Advertisement
If option Ignition Unlock Only is selected, the system will
is turned to the
OFF
position and that the Brake Pedal was pressed at least once).
Secure Lock
This feature allows the Remote Car Starter to control certain OEM factory Alarm systems
without requiring the use of other wires for disarming the OEM Alarm. (Namely, this
feature is designed for OEM systems which use the factory Lock wire to arm the Alarm
and the Unlock wire to disarm it.)
Standard Secure Lock
If this Option is selected, upon receiving a remote
the Doors (disarming the factory Alarm); 1/2 sec. after remote start Secure Lock will re-
lock the Doors. 4 seconds after shutdown, Secure Lock will re-lock all Doors (arming
the system once again). Please note that most OEM systems will not rearm the Alarm
while the Engine is running, but will still lock the Doors.
Smart Secure Lock
If the vehicle is initially locked, upon remote
unlock pulse and a disarm pulse before the Engine is started. The Remote Car Starter
will
again when the Engine is running, and
LOCK
down.
If the vehicle is initially unlocked, upon remote
the Engine and arm the Starter Kill, but the Doors will not be locked or unlocked at any
moment of the sequence.
Lock Pulse Duration
The duration of the Lock and Unlock pulses can be configured as follows:
•
(Default) 7/10-sec.
•
4-sec.
LOCK/UNLOCK
•
A single 7/10-sec.
for double-pulse disarm/unlock systems.
•
1/10-sec.
Engine Run Time
Use this Function to configure the length of time the Engine will be left running under
remote control. The Remote Car Starter will allow the Engine to run for either 4, 15 or 25
min. in Gas Mode and 9, 20 or 30 min. in Diesel Mode. Standard default Run Time is 15
minutes in Gas mode and 20 minutes in Diesel mode.
Starter Kill (Installation)
The Remote Car Starter is equipped with a selectable Passive or Active-arming Starter
Kill circuit that will prevent the vehicle from being started with the Ignition Key when the
Remote Car Starter is armed. The Starter Kill wire will provide a constant 500-mA.
negative output when the system is armed (locked by remote control) and can be
connected to an external Starter or Ignition interrupt relay (see diagram below).
The Starter Kill circuit can be set to arm in either Passive Mode or Active Mode
P. 26
position (provided that the Ignition key was in the
and 7/10-sec.
LOCK
pulses to control vacuum Door Lock systems
pulse and two 1/4-sec.
LOCK
and 1/10-sec.
LOCK
UNLOCK
UNLOCK
signal, Secure Lock will
START
the Remote Car Starter will trigger an
START
once again 4 seconds after shut-
LOCK
the Remote Car Starter will start
START
pulses
UNLOCK
pulses
UNLOCK
pulses
Installation Guide AS-2360TW
all Doors when the key
IGNITION ON (RUN)
UNLOCK
Advertisement
Table of Contents
