Supplementary Information; Fifth Relay Output (2 Crank); Nd Ign, Acc Or; Caution - Autostart AS-2510 TW Installation Manual

Supplementary Information

Fifth Relay Output (2

Caution!

Only one set of pins can be used at one time. Using more than one Jumper may
result in serious damage to the vehicle.
The relay output rating on this unit is 25 A at most. Defective OEM solenoid switches
can sometimes draw up to 50 or 60 A, causing the 30 A Fuse to blow. Always verify
your circuit with an appropriate measuring device.

Ignition-controlled Door Locks

( by default.) This feature will
ENABLED
Pedal is pressed while the Ignition Key is in the
all Doors when the Ignition Key is turned back to the
UNLOCK
If Ignition Lock Only is selected, the system will only
is pressed while the Ignition Key is in the
If option Ignition Unlock Only is selected, the system will
turned to the position (provided that the Ignition key was in the
OFF
and that the Brake Pedal was pressed at least once).

Secure Lock

( by default.) This feature allows the Remote Car Starter to control certain OEM factory
OFF
Alarm systems without requiring the use of other wires for disarming the OEM Alarm.
(Namely, this feature is designed for OEM systems which use the factory Lock wire to arm
the Alarm and the Unlock wire to disarm it.)

Standard Secure Lock

If this Option is selected, upon receiving a remote
Doors (disarming the factory Alarm); 1/2 sec. after remote start Secure Lock will re-lock the
Doors. 4 seconds after shutdown, Secure Lock will re-lock all Doors (arming the system
once again). Please note that most OEM systems will not rearm the Alarm while the Engine
is running, but will still lock the Doors.
P. 16
nd
IGN, ACC or CRANK)
Remote Car Starters of this series are
equipped with an on-board high-current
programmable 5
to power a second Ignition, Accessory or
Crank wire.
The Unit uses 3 sets of pins; each set
corresponds to a specific function of the
output. In order to activate one of the three
possible functions, you must place the
Jumper (supplied) on one of the three
sets of pins and connect the 14 AWG wire
to the second
vehicle.
all the Doors of the vehicle when the Brake
LOCK
IGNITION ON (RUN)
LOCK
IGNITION ON (RUN)
signal, Secure Lock will
START
Installation Guide AS-2510 TW
th Relay that can be used
wire of the
IGN. / ACC. / CRANK
position. The unit will
position.
OFF
all Doors when the Brake Pedal
position.
all Doors when the key is
UNLOCK
position
IGNITION ON (RUN)
UNLOCK
the