Table of Contents
Advertisement
To install this unit in a vehicle with an automatic transmission:
1.
Cut the loop on the pc board (Yellow wire).
2.
Make sure the Black/White handbrake wire is not connected to any of the vehicle
circuits.
3.
Make all the regular connections.
4.
Power up the unit. The parking lights will flash 4 times.
5.
When learning the first transmitter, the parking lights will flash 5 times quickly then give
2 slow flashes, confirming that the module is set to automatic mode.
6.
Upon the first successful remote start once the yellow loop has been cut, the
system will lock the transmission settings to automatic mode.
Note: If upon pressing the
Black/White handbrake wire is not connected and that the yellow loop is cut and isolated.
Transmitter Programming Procedure
1. Enter programming mode (see on page 14) the parking lights will stay on for up to 20
seconds.
2. Before the lights go out, turn the ignition key to the
immediately back to the
3. Press and hold the
4. The transmitter has been stored in memory.
Note: Each unit can store 4 remotes in its memory.
Entering Programming Options
1. Enter programming mode (see on page 14) the parking lights will stay on for up to 20
seconds.
2. Before the lights go out, press and hold the brake pedal and then press one of the following
buttons:
3. The parking lights will flash and the horn will honk (if programmed) once or twice to confirm
entry into a menu.
4. Release the brake pedal.
Once the desired menu has been selected, the unit will fall (by default) into feature #1 of that
menu; you can now select the option you want in feature 1. Once this option has been chosen, the
unit will move on to feature 2 of the menu selected, and so on.
Programming Options
MENU 1
FEATURE 1 – Ignition-controlled door locks
OPTION 1*
OPTION 2
FEATURE 2 – Secure Lock
OPTION 1*
OPTION 2
FEATURE 3 – Starter Kill arming mode
OPTION 1*
OPTION 2
OPTION 3
P. 16
button, the parking lights give 3 slow flashes, make sure that the
ΙΙ
position.
OFF
button and keep it down until the parking lights flash 5 times quickly.
Ι
................... to access menu 1; or
BUTTON Ι
.......................to access menu 2.
BUTTON ΙΙ
BUTTON Ι
BUTTON ΙΙ
BUTTON Ι & ΙΙ
* INDICATES DEFAULT SETTING
Ignition-controlled door locks
Ignition-controlled door locks
Secure lock
DISABLED
Standard secure lock
Passive arming (60 sec.)
Active arming
Passive arming (1 min.)
Note: When SK is armed, pressing
(when in MENU 2 FEATURE. 6, opt.1)
position, then to
OFF
for
Option 1,
for
Option 2,
for
Option 3.
DISABLED
ENABLED
ENABLED
Ι
will always give an UNLOCK output
and
IGNITION ON (RUN)
Installation Guide
Hide quick links:
Advertisement
Table of Contents
