Server Technology switched pro2 User Manual page 18

Network Defaults
The PRO2 is configured with the following network defaults to allow unit configuration out-of-the-box through either
Telnet or Web. However, note that when the PRO2 is installed on a DHCP-enabled network, the following network
defaults do not apply because the PRO2 ships with DHCP support enabled by default.
Network Defaults (for non-DHCP-enabled networks):
•
IP Address: 192.168.1.254
•
Subnet Mask: 255.255.255.0
•
Gateway: 192.168.1.1
Reconfigure the Network Connection
A local PC network connection must be reconfigured as follows. For detailed instructions about this connection,
contact your system administrator. Note that a restart of the system may be required for the network reconfiguration
to take effect.
•
192.168.1.x (where "x" is 2-253)
IP Address:
•
Subnet Mask: 255.255.255.0
Installing the PRO2
Switched PRO2 – User Guide
•
18